Pemanfaatan Limbah Botol Plastik Jenis PET pada Pembuatan Beton Berpori

Authors

  • Nurfitri Anggraeni UIN Sunan Ampel Surabaya
  • Yusrianti Yusrianti UIN Sunan Ampel Surabaya
  • Amrullah Amrullah UIN Sunan Ampel Surabaya

DOI:

https://doi.org/10.29080/alard.v6i1.994

Keywords:

Porosity, PET plastic waste, water absorption, porous concrete

Abstract

The waste problem is a big problem all over the world. Every year the use of plastic has increased quite high. This increase is based on changes in living conditions and development of activities. With the accumulation of plastic waste, it will have a bad impact on the environment. To overcome this problem, this research will recycle plastic waste as a mixture of construction materials. This study aims to determine the use of PET plastic bottle waste materials to substitute fine aggregate on the compressive strength and water absorption test. The experimental method is used in research by observing and testing carried out in the laboratory using 12 test objects, using SNI to plan the concrete mixture. The results showed that the compressive strength test value was 0% 24.85 MPa, 3% 8.42 MPa, 6% 4.79 MPa, and 9% 2.56 MPa. And the results of the water absorption test resulted in an average of 0% of 0.39%, 3% produced 2.46%, 6% produced 3.38% and 9% produced 4.10%.

Downloads

Download data is not yet available.

References

Azwanda, dkk. (2017). Pengaruh Substitusi Bahan Anorganik Plastik Terhadap Kuat Tekan Beton Normal. Staff Pengajar Jurusan Teknik Sipil Vol. 3 No. 4.

Enda, Dedi., dkk. (2019). Penggunaan Plastik Jenis PET Sebagai Pengganti Semen pada Pembuatan Paving Block. Jurnal INVOTEK POLBENG, Vol.9 No. 2. DOI: https://doi.org/10.35314/ip.v9i2.1010

Hanta, Lius, Amelia. (2015). Studi Eksperimental Pengaruh Bentuk Agregat Terhadap Nilai Porositas dalam Campuran Beton Berpori pada Aplikasi Jalur Pejalan Kaki. FSTP International Symposium, Unila Bandar Lampung.

Husaini, dan Mahdi. (2015). Penggunaan Limbah Botol Plastik Sebagai Agregat Pada Campuran Beton dengan Penambahan Silika Fume. Lentera Vol. 15 No. 15.

Indah, Arintha D.S. (2015). Pengaruh Serat Polipropilen dalam Beton Berpori. Tugas Akhir Institut Teknologi Sepuluh November.

Downloads

Published

2020-12-30

How to Cite

Anggraeni, N., Yusrianti, Y., & Amrullah, A. (2020). Pemanfaatan Limbah Botol Plastik Jenis PET pada Pembuatan Beton Berpori. Al-Ard: Jurnal Teknik Lingkungan, 6(1), 53–59. https://doi.org/10.29080/alard.v6i1.994

Issue

Vol. 6 No. 1 (2020): September

Section

Articles

License

Authors who publish with this journal agree to the following terms:

  1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.